Operating
Place the staple gun against the work surface so that the nose-piece of the too is where you want the staple to be located.
Push the tool firmly down on the work surface
Squeeze the trigger to fire a staple
To fire the staple gun simply squeeze the trigger
Never operate too unless safety nose is contact with workplace.Do not operate tool without fasteners or damage to tool may result.
Never fire fasteners into air because fasteners may injury operator or others and damage to tool may result.
Maintenance required | Description | Tools or materials required | Maximum service interval | ||
Each use or every 2 hrs | Monthly | As needed | |||
General inspection-free movement | Trigger, spring, safety mechanism | None | √ |
|
|
In-depth inspection | Worn or broken parts |
|
| √ | √ |
Replace worn or broken parts |
|
|
|
| √ |
Lubrication | See below | Pneumatic tool oil | √ |
|
|
WARNING:It any of the following symptoms appears during your operation stop using the too immediately,or serious personal injury could result.Only a qualified persons or an authorized service center can perform repairs or replacement of tool Disconnect tool from air supply before attempting repair or adjustment.When replacing O-rings or cylinder,lubricate with air tool oil before assembly
Problem | Check | SOLUTIONS |
stapler operates but no nail is driven. | 1. Check for jam. 2. Check feeder function. 3. Check for proper nails. | 1. Clear a nail jam. 2. Clean and lubricate 3. Use correct nails. |
Week drive.Slow to cycle | 1. Check air pressure 2. Drive blade worn? 3. Piston O-ring worn or damaged | 1. Increase air pressure.Do not exceed 120 psi.Use pneumatic oil. 2. Purchase Drive Pin or Seal |
Purchase Drive Pin or Seal | 1. Check air pressure | 1.Reduce air pressure 60-100 psi. |
Skipping nails,Intermittent feed. | 1. Check for proper nails. 2. Check nail feeder function 3. Piston O-ring cut or worn out 4. Check for proper nails | 1. Use only recommended nails. 2. Clean and lubricate and use pneumatic oil. 3. Purchase Seal. 4. Use only recommended nails. |
Nails jam, Driven nail is bent | 1.Drive blade worn. | 1.Purchase Drive Pin. |
Drives properly at normal speed but does not drive fully drive at faster nailing speed | 1.Check inside hose diameter. | 1.Use larger air hose. |
Tooll jams. | 1. Incorrect or damaged fasteners. 2. Damaged or worn driver guide. | 1. Change and use correct fastener. 2. Check and replace the driver. |
RONGPENG R8016 GA21 Wide Crown Stapler Air Powered Nail Gun Air Nailer Aluminum Housing For Nailing
Description :
1) Innovative design with light weight.
2) Rear exhaust to protect work surfaces.
3) Steel top cap can be used as hammer at your needed working situation.
4) Soft grip handle with extra comfort and control.
5) Professional tool with hardened one piece piston.
6) Hard coated magazine increase durability.
Heat treated air inlet plug prolonged the life.
8) Easy loading latch for more comfortable loading. Standard equipment: stapler, carrying case, oil, allen wrenches and operating manual.
Model No | R8016 |
Dimension | 220.5x140.5x43.2mm |
Weight | 0.91kg(2.0Lb) |
Operating Pressure | 72-187PSI(5-6br) |
Max.pressure | 120psi(8.3bar) |
Load Capacity | 125pcs |
video
https://rongpeng.store